NEED EXPRESS SAME DAY DELIVERY SERVICE? WE’VE GOT YOU COVERED AT RM9.90 NETT! Express Delivery
Cart 0

KTH Epoxy Floor Paint (4 Liter + 1 Liter)

RM 135.00


Product Description


Epoxy Enamel is a high performance two-pack epoxy resin based paint cured by polyamide activator. It has excellent protection against fresh and salt water, abrasion resistance, chemical resistance and resistant to crude and heavy oils.

地坪漆是一种高性能的双组分环氧树脂类涂料由聚酰胺活化剂固化,它具有优良的防淡水和咸水,耐磨性,耐化学性和耐粗和重质油。

Packing: 4Liter + 1Liter

Colour: As Per Catalogue

DUE TO MONITOR DIFFERENCES, ACTUAL COLOR MAY VARY SLIGHTLY FROM WHAT APPEARS ONLINE.
CONTACT US FOR COLOR SAMPLES IF YOU NEED HELP SELECTING A FINISH.


Surface Preparation


Concrete Surface 混凝土表面 :
Remove all previous coating and chalk by light abrasive blasting. If abrasive blasting is not available, etch the new and uncoated concrete surface with about 5% sulphuric acid solution followed by thorough rinsing with clean water. Allow the surface to dry completely prior to paint application.
通过光喷砂除去所有以前的涂层和白垩。使用机器磨粗地面使地面容易上漆及加强附着性或使用5%硫酸溶液,随后彻底清洗干净。待表面干燥后就可粉刷。

Steel Surface 铁的表面 :
The mild steel substrate must be completely dry and free from rust, mill scale, dirt, grease and other contaminants before painting. For maximum adhesion and durability of paint performance, all bare metals should be sanded properly.
铁基本身必须完全干燥,无生锈,氧化皮,污垢,油脂及其它杂质。要获得最大附着力和涂料性能的耐用性,所有铁应适当打磨。

Aluminium and Galvanised Iron Surface 铝和镀锌铁表面处理 :
Remove all oil, grease and dirt by using solvent or other cleaning chemicals.
使用溶剂或其他化学清洗剂除去所有的油,油脂和污垢。


Product Preparation


4 parts by volume of Epoxy Finish (Base) to 1 part by volume of Hardener. Stir the content of the base component, continue stirring and gradually add the total contents of the hardener component, continue stirring until a homogeneous mix is obtained. However if thinning is required, not more than 10% of thinner may be added.

4LT的环氧面漆(BASE)至1LT的硬化剂。 搅拌基础组分的含量后,继续搅拌并逐渐加入硬化剂组分的总含量。
继续搅拌直至获得均匀的混合物。 如果需要稀释,可加入不超过10%的稀释剂。